• Compact (1U) and lightweight Class D fixed installation amplifier
  • Lo-Z (2, 4, 8 ohms), mono, stereo and bridge modes
  • Universal SMPS (100 - 250 V AC) with PFC

The DAP SI-2.750 is a compact and lightweight 2-channel power amplifier for fixed installations. In a 1U rack space it delivers 2x 750 W into 4 ohms, is capable of driving 2-ohm loads and can be bridged for even more power. It is designed for low impedance and high current with excellent stability.


It has a clip limiter and DC output protection to prevent damage to the loudspeaker. Output overload and short-circuit protection protects the amplifier from faults, as does over-temperature protection and high-temperature power attenuation.


Signal, Clip, Fault and Power LEDs indicate the status of the amplifier. The output level can be adjusted for each channel using the volume controls. Gain can be set on the rear panel for 0.775 V input or 32 dB gain, and a mode switch selects stereo, mono and bridge modes.


The universal switching power supply uses active PFC and soft-switching technology, accepts input voltages from 100 - 250 V AC and is optimised for the audio power amplifier.


Specifications


Outputs

2 ohms Stable            Yes

Output per Channel into 8 ohms at 1 kHz             500 W

Output per Channel into 4 ohms at 1 kHz             750 W

Output per Channel into 2 ohms at 1 kHz              1130 W

Bridge Output into 8 ohms at 1 kHz                 1500 W

Bridge Output into 4 ohms at 1 kHz             2250 W

Output Channels              2

Output Mode           Bridge, Mono, Parallel, Stereo

Output Connector                 Speaker Connector 4 pole


Inputs

Mono Inputs               2

Mono Input Connector                  3-pin XLR

Mono Input Impedance               20000 Ω

Balanced Mono Input Sensitivity                 32 dBu


Audio Specifications

THD Level                < 0.05 %

Signal-to-noise Ratio                 > 100 dB

Slew Rate                50 V/μs

Amp Technology                    Class D

Damping Factor               1000 :1

Crosstalk                75 dBu

Frequency Response Minimum                    20 Hz

Frequency Response Maximum                20000 Hz


Electrical Specifications and Connections

Power Supply               100-240 V AC 50/60 Hz

SMPS                Yes

Power Consumption                460 W

Power Connector In                IEC


Mechanical Specifications

Height (mm)               45 mm (1.772″)

Width (mm)                  483 mm (19.016″)

Length (mm)                  296 mm (11.654″)

Installation Depth (Excl. Connector)                   296 mm (11.654″)

Flightcase Size                 19"

Rack Units                 1 U

Housing                  Steel

Colour                Black

Finish                Powder Coating

Weight               5 kg (11.023 lb)

IP Rating              IP20 (indoor use only)


Product Properties

Electronic Protection             Clip limiter, DC voltage, Overheat, Overload, Under voltage

LED Indicators             Clip, Power, Protect, Signal


Thermal Specifications

Maximum Ambient Temperature              40 °C (104 °F)

Minimum Ambient Temperature            -15 °C (5 °F)

Maximum Surface Temperature              70 °C (158 °F)


Included Items

Included Cables              IEC cable

Included Accessories            Rubber feet

Write a review

Note: HTML is not translated!
    Bad           Good

DAP SI-2.750

  • Brand: DAP Audio
  • Product Code: D4230
  • Availability: 5-7 Days
  • £380.00

  • Ex Tax: £316.67